ES Windows Shingle, Tile & Metal Roofing Nationwide | TruePane Windows & Doors

ES Windows Shingle, Tile & Metal Roofing in Deerfield Beach: What to Know First

We provide independent ES Windows shingle, tile and metal roofing service in Deerfield Beach, and most jobs are complete within one visit. ES Windows are a premium product, but the roofing integration around them is where we see real trouble: flashing details, curb mounts, and sealant failures that let salt air and afternoon thunderstorms work their way into the frame. We’re not the cheapest bid in the room, and we won’t pretend to be. We give you a square deal, in writing, before any work starts. If you own ES Windows in Deerfield Beach and the roof around them is leaking, sagging, or pulling away, call us at (786) 743-5882 for a free estimate.

Call (786) 743-5882

How ES Windows Products Fail - and How We Fix Them

• ES Windows ES-7000 Series casement and fixed units: curb-mount flashing separation. In Deerfield Beach, the daily expansion and contraction from sun on a tile roof works the flashing loose around curb-mounted ES windows. We see sealant that looks intact from the ground but has sheared away from the aluminum frame underneath. Our fix is to remove the old flashing, re-bed the curb with closed-cell foam tape, and mechanical-fasten new flashing instead of relying on sealant alone.
• ES Windows ES-2100 sliding glass door tracks: standing water from flat tile roof overhangs. Tile roofs on older Deerfield Beach ranch homes often have very little slope over a slider. When the roof drains toward the track, the weep system clogs with wind-blown sand and the track starts holding water. ES Windows sliders have weep holes that are smaller than what we see on PGT or CGI, and they clog faster. We clear the weeps, check the track slope, and if the roof drainage is the real problem, we correct the flashing so water never pools at the door.
• ES Windows ES-9000 impact picture windows: glazing bead shrinkage under metal roof heat. A standing-seam metal roof in Deerfield Beach can push surface temperatures well past 140 degrees in August. The vinyl glazing bead on some ES Windows picture units shrinks slightly over years of that heat cycle, leaving a hairline gap at the corners. Water finds it. We replace the bead with new OEM stock and re-set the glass with fresh setting blocks, then verify the drain path is clear.
• Nail-fin ES Windows on shingle roofs: step flashing cut too short at the sill. This is the most common ES Windows failure we walk into after a reroof. The roofer ran step flashing up the sides but stopped the sill flashing short, so wind-driven rain gets under the window at the bottom corners. We pull the bottom course of shingles, install proper sill pan flashing that extends past the frame, and re-lay the shingles. The window itself is usually fine; the flashing was not.
• Aluminum frame corrosion at the roof line on ES Windows oceanfront units. On homes within a mile or two of the beach in Deerfield Beach, salt air concentrates at the point where the roof meets the window head. Bare mill-finish aluminum on older ES Windows frames oxidizes and pits at that line. If caught early, we can clean, prime, and seal the frame. If the corrosion has eaten into the screw bosses, we replace the frame section and rebuild the head flashing.

Our ES Windows Shingle, Tile & Metal Roofing Process

1. 1
   You call, a person answers. We schedule a time that works and show up when we say. Background-checked, uniformed, and ready to look at the actual window and roof condition.
2. 2
   We inspect the roof-to-window connection, not just the window. Dale Kessler reads the rough opening honestly. If the frame is square and the glass is sound, we tell you. If the flashing is the failure, that’s what we quote.
3. 3
   Parts decision on paper. For ES Windows, we use OEM parts when the unit is under warranty or when fitment requires it. Where an aftermarket weatherstrip or sealant outperforms OEM at a lower price, we quote both lines side by side and let you choose. No surprises.
4. 4
   The repair, done right. We remove the failed components, correct the underlying flashing or drainage issue, and re-install everything to shed water. If it is not in the contract, it is not in the scope.
5. 5
   We test, then we show you. We run water over the repaired area while you watch. If it drips, we’re not done. If the pane is not true, the job is not done.
6. 6
   Paperwork before we leave. Both warranty layers registered in writing, durations stated, and the Done Right Promise applied to the work. No fine print that covers neither.

What ES Windows Shingle, Tile & Metal Roofing Costs in Deerfield Beach

ES Windows roofing repairs in Deerfield Beach typically run between $220 and $1,800 depending on what failed. A simple step flashing replacement on a shingle roof runs $220 to $450 per window. Curb-mount re-flashing on a tile roof runs $600 to $1,100. A full sill pan retrofit under an existing ES sliding door runs $900 to $1,400. Replacing a corroded frame section at the head of an impact window runs $1,200 to $2,000. The cost moves on roof type, access, and whether the window itself has been damaged by the water. We quote fixed pricing with no change orders. Call (786) 743-5882 for a written line-item estimate. Free, and we stand by it.

Why Deerfield Beach Homeowners Call TruePane Windows & Doors for ES Windows Work

We’ve served Deerfield Beach since 2008 through Dale Kessler’s craft tradition, and we plan to be here in thirty more. The Done Right Promise covers every ES Windows repair we make: if it is not done right, we make it right. No paperwork, no arguing. Our techs work on ES Windows regularly and also know the PGT, CGI, CWS, and ECO Window Systems lines, so if a unit needs full replacement instead of repair, we can quote you side by side on paper and show you what each line actually costs. A live person answers the phone 24 hours a day. We carry a folding rule in the truck, and we still measure twice.

FAQs